Page 6
For technical questions, please call 1-888-866-5797.
Item 56478
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
cautiOn! Make sure the Miter Saw (not included) is
unplugged from its electrical power supply source
before attempting to mount on the Saw Stand.
10. With the help of an assistant, lift and mount the Miter
Saw/Mounting Brackets onto the Main Frame (20).
a. On both Brackets, squeeze the Mounting
Bracket Lever (24) to open it.
b. Align the Clamp Blocks, on the inside end of the
Brackets, to one side of the Main Frame. Then,
guide the Saw/Brackets down so that the Levers
align with the other side of the Main Frame.
c. Release the Levers once they and the Blocks are
aligned with the Frame. Releasing the Levers
will lock the Saw/Brackets onto the Main Frame.
11. To move the Saw, squeeze the Lever on each
Bracket. Slide the Saw across the Frame and
into its desired position. Once in position,
release the Levers to lock the Saw in place.
12. To remove the Saw with attached Mounting
Brackets from the Saw Stand, squeeze the Lever
on each bracket. This will open the Levers and
allow you to lift the Saw/Brackets off of the Stand.
13. Once the Saw is positioned, check that it
is fully seated and locked in position. The
Clamp Blocks should be on the same side
of the Stand as the Saw operator.
3
1
Miter Saw
clamp Block (27)
Main Frame
align clamp
Block with
Main Frame
Main
Frame
(20)
universal Mounting platform
1. For Miter Saws with unusual mounting patterns,
a mounting platform can be used. Use minimum
3/4″ thick plywood that is at least 4″ wider than
the widest part of the miter saw base and at least
as deep as the smallest depth of the miter saw
base or a minimum of 16″, whichever is larger.
2.
Ensure the plywood is square and drill 3/8″ holes
in the four corners, 1″ in from the sides. These will
be the holes for the two Mounting Brackets (21).
3/8" Dia.
Hole
16" Deep
Minimum
1"
Width of Base plus 4"
3/4" thick plywood
Miter Saw Base
1"