
Page 4
For technical questions, please call 1-888-866-5797.
Item 56478
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
Specifications
Maximum Load
350 lb
Maximum Extension
80"
Setup - Before use
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
note:
For additional information regarding the parts listed in the
following pages, refer to
Parts List and Diagram
on page 10.
Set up
1. Lay the Saw Stand upside down on the
floor with the folded legs facing upward.
2. Push the Lock Pin (7) in and lift
Support Leg (3), (4) up.
3. Continue lifting until the Lock Pin
clicks into place at the top hole.
4. Repeat for the other three Legs.
5. Lift and turn the Saw Stand over to
an upright working position.
6. Make sure all four Lock Pins are engaged,
and the Legs and Saw Stand are stable.
push Lock
pin (7) in
Support
Leg (3), (4)
“click”
assembly
1. Slide a Workpiece Support (19) into the
end of an Extension Arm (12).
2. Thread a Lock Knob (13) into the hole
on the side of the Extension Arm.
3. Adjust the Support to the desired height
and secure it to the Extension Arm by
twisting the Lock Knob until tight.
4. Repeat for the other Workpiece Support and
secure it to the other Extension Arm.
1
2
Lock
Knob
(13)
Workpiece
Support
(19)
Extension
arm (12)