WARPP INARC 200 IDS, Руководство по эксплуатации

Страница: 14 / 19

§
4.6 Operation Environment
●
Height above sea level is below 1000 m.
●
Operation temperature range : -10
℃
- + 40
℃
●
Relative humidity id below 90% (+20
℃
)
●
Preferably site the machine some angles above the floor level, the Max. angle does not exceed 15
degree.
●
Protect the machine against heavy rain or in hot circumstance against direct sunshine.
●
The content of dust, acid, corrosive gas in the surrounding air or substance can not exceed normal
standard.
●
Take care that there is sufficient ventilation during welding. There is at least 30cm free distance
between the machine and wall.
§
4.7 Operation Notices
●
Read
§
1 carefully before attempting to use this equipment.
●
Connect the ground wire with the machine directly, and refer to
§
3.5
●
Input power must be AC as one phase, 50HZ, 220/230V. Forbid working in lacking any phase.
●
In case closing the power switch, no load voltage may be exported. Do not touch the output electrode
with any part of your body.
●
Before operation, no concerned people should be left. Do not watch the arc in unprotected eyes.
●
Ensure good ventilation of the machine to improve duty ratio.
●
Turn off the engine when the operation finished to economize energy sources.
●
When power switch shuts off protectively because of failure. Do not restart it until problem is resolved.
Otherwise, the range of problem will be extended.
5 Maintenance & Troubleshooting
§
5.1 Maintenance
In order to guarantee that arc welding machine works high-efficiently and in safety, it must be maintained
regularly. Let customers understand the maintenance methods and means of arc welding machine more,
enable customers to carry on simple examination and safeguarding by oneself, try one
’s best to reduce
the fault rate and repair times of arc welding machine, so as to lengthen service life of arc welding
machine. Maintenance items in detail are in the following table.
●
warning: For safety while maintaining the machine, please shut off the supply power and wait for 5
minutes, until capacity voltage already drops to safe voltage 36V.