4
5
GROUNDING INSTRUCTIONS
• For your protection, this appliance is equipped with a
3-conductor cord set.
• 120 Volt units are supplied with a molded 3-prong grounding-
type plug (NEMA 5-15P) and should be used in combination
with a properly connected grounding type outlet as shown in
Figure A.
If a grounding type outlet is not available, an adapter, as shown in
Figure B, may be utilized to enable a 2-slot wall outlet to be used
with a 3-prong plug (except in Canada and Europe). As shown in
Figure C, the adapter must be grounded by attaching its grounding
lug under the screw of the outlet cover plate.
Caution:
Before using an adapter, you must be sure that the outlet
cover plate screw is properly grounded. If in doubt, consult a
licensed electrician.
Never use an adapter unless you are sure it is properly grounded.
Note: Use of an adapter is not permitted in Canada and Europe.
Green/Yellow: Earth/Ground. Blue: Neutral. Brown: Live.
Note: User-installed cord set plugs are not permitted in Europe.
This appliance is for 120 Volts only and should not be used with a
converter.
MX1000R (Model: MXMPBKP6) OPERATION
1. Before starting, make sure that the
blender is unplugged.
2. With the unit in OFF position, place
container on blender base. Be sure
container is fully seated and that drive
coupling is properly engaged. Plug
blender cord into outlet.
3. Put ingredients into container and
cover it. Do not fill above MAX line.
4.
CAUTION: DO NOT use carbonated liquids in the blender
jar or any blending container. Using carbonated liquids
in the blender jar or any blending container may result in
injury.
5. This blender has 2 speed settings: HI and LOW. Press paddle
switch to desired position. To crush ice quickly, use HI speed
setting.
6. When finished blending, set paddle switch to OFF position.
7. This blender is equipped with a pulse option. Hold paddle
switch in the lower position to engage PULSE function. Unit
will run on HI speed until the paddle switch is released.
8. Allow motor to come to a complete stop before removing
container from blender base. Never place the container on the
motor base or remove it from the motor base while motor is
running.
9. Always hold container with one hand when starting and while
blending. Never operate without jar lid.
10. Wash and dry container after each use. See Cleaning and
Sanitizing instructions.
IMPORTANT
HOT BLENDING INSTRUCTIONS
To minimize the possibility of being scalded when blending hot
materials, the following precautions and procedure must be
observed.
• Hot materials are those that are 100°F (38°C) or hotter.
• Limit the amount of materials processed to 1 pint.
• Completely remove the center portion of the two-piece
container lid before starting motor (this will allow venting of
the rapidly heated and expanding
air inside the container when blender is running).
• Always start blending on lowest speed setting, and then
progress to desired speed.
• Never stand directly over blender when it is being started or
while it is running.