890557_d•en•01.07.2014
We reserve the right to carry out improvements
58
Wisotronic 1-channel
Operating instructions
Position -temp COOLGE
The “Position D-temp COOLER” value specifies the position or max. position
(for step settings) to which a window is to be moved. The setting range is
0...100%.
Turn the touch wheel to set the limit value “Position D-temp COOLER”.
The function button [
---
] leaves the position unchanged; the function button
[
Stand.
] sets the value for the “Position D-temp COOLER” to 100% (factory
settings).
Slat angle -temp COOLGE
This setting is only useful when you have chosen a slat product (external or
internal venetian blinds). If you have connected a slat product (such as an
external venetian blind), you can specify how the slats are to be set after
movement to the "D-temp COOLER" position is completed.
Turn the touch wheel to set the value "Slat angle D-temp COOLER".
The function button [
---
] leaves the slat angle unchanged; the function
button [
Stand.
] sets the value for the “Slat angle D-temp COOLER” to the
product-specific factory setting.
Limit value -temp WDEMGE
The "D-temp WARMER" limit value specifies by how many degrees the out-
side temperature must be lower than the inside temperature for the window
to stay open. If the differential temperature falls below the "D-temp WARMER"
limit value, the window is closed.
Example
Your max. comfort temperature is, for example, 26 °C and it has already
been reached. The window was already opened automatically. The outside
temperature rises and the difference temperature between outside and inside
sinks below the limit value "diff temp WARMER". The window is now closed.
Assuming you set 2 °C as "Limit value WARMER" and the rising outside tem-
perature is only 2 °C or less below the inside temperature; the window will
be closed then. The setting range is 1...25 °C.
Turn the touch wheel to set the limit value "D-temp WARMER".
The function button [
---
] deactivates the evaluation of the limit value "D-temp
WARMER"; the function button [
Stand.
] sets the value to 2 °C (factory set-
ting).
Uemperature control
