waratah HTH622B SIII, Руководство оператора

Страница: 18 / 66

protection and other protective equipment when
welding.
Keep the welder ground clamp as close to the welded
area as possible to prevent welding current travelling
through the electrical system.
T7M7G6M,00004E5-19-04APR21
Accumulator Repair Safety
TS281—UN—15APR13
Escaping fluid or gas from pressurised hydraulic
accumulator systems can cause serious injury. Extreme
heat can cause the accumulator to burst, and
pressurised lines can be accidentally cut. Do not weld or
use a torch near a pressurised accumulator or line.
Relieve pressure from the hydraulic system before
removing the accumulator.
T7M7G6M,00004E6-19-02APR21
Slotted Link (Optional Feature)
XJ1281195—UN—10JUL19
If the head has a slotted link installed, keep away from
the slot, as any movement in the feed arm or harvester
head may cause pinching.
T7M7G6M,00004E7-19-02APR21
Chain Shot Guard Inspection
CAUTION: Serious injury or death can occur.
The harvester head can move unpredictably
during service procedures. The frame lock pin
must always be used during maintenance or
adjustment procedures.
6
3
2
1
5
4
TX1078030—UN—08JUN10
Saw
TX1305897A—UN—04NOV20
Typical saw components
1 — Saw chain
2 — Saw bar
3 — Saw bar tip
4 — Saw chain drive sprocket
5 — Saw chain catcher
6 — Chain shot guard
The function of the chain shot guard (6) is to reduce the
risk of serious injury or death to operators and
bystanders from flying saw chain pieces. The chain shot
guard must be in place and structurally sound to absorb
the energy from a broken saw chain (1) and reduce the
whip action that causes a second break of the saw
chain, ejecting pieces of the cutting saw chain at high
speed. For additional information about chain shot, refer
to Avoid Chain Shot in the safety section of this manual.
Inspect the chain shot guard daily or when saw chain
maintenance is performed.
Saw chain breaks are the primary cause of wear or
damage to the chain shot guard.
The chain shot guard, cap screws, and hardware should
be replaced yearly or when excessively worn or
damaged.
Safety: Maintenance Precautions
1-3-7