W&T Electronics 58210, Руководство пользователя, Страница: 34 / 63

34
W&T
Modem Operation
• S=0|1|2|3
The LAN-Modem has a non-volatile memory for up to four
destination IP addresses. By specifying a value between
0 and 3, the IP addresses stored here is used for the call
set-up. If only „S“ is entered without a numerical value,
the addresses stored in position 0 is used. The command
&Zn is used to write to the non-volatile address memory.
• L
When using „L“ instead of the IP address, the dial-up
is repeated using the last used values. If no address
has been dialed since the last reset of the LAN-Mo-
dem, the message „ERROR“ is returned.
• ; (Semicolon)
Entering a semicolon to terminate the dial-up command
causes the LAN-Modem not to automatically return to
data mode after a successful call set-up, but rather to
remain in command mode.
Example of dial-up command:
ATD172.16.1.1
ATD172016001001
ATDT172.16.001.001
All three commands have the same effect: An attempt is
m a d e t o s e t u p a c a l l t o t h e L A N - M o d e m h a v i n g I P
address 172.16.1.1.