5.0 INSTALLATION AND FIXING
SILOTOP R03
2
FIL.100.--.M.EN Issue: A2
06.12
33
Parameter value
Indicator of parameter
to be set
Programming mode
The programming procedure is activated by pressing
P2
and
P3
(ENTER) simultaneously. On pressing the
NH\VWKH/+GLJLWRQWKHGLVSOD\ZLOOVKRZDQLGHQWL¿FDWLRQQXPEHUIURPWRUHODWLYHWRWKHSDUDPHWHUEHLQJ
examined (see table), while the two remaining ones or just the last one, to the RH, indicates the value selected
for that parameter.
At this point
P1
(UP) or
P2
(DOWN) can be pressed to scroll through the functions that can be set (the LH
GLJLWLQGLFDWLQJWKHSDUDPHWHUÀDVKHV2QFHWKHSDUDPHWHUWREHPRGL¿HGKDVEHHQLGHQWL¿HGNHHS
P2
and
P3
(ENTER) pressed to enter the mode for programming the parameter concerned (the two digits to the RH
',*,7DQG',*,7RURQO\WKHODV',*,7ÀDVKZKLOHWKHGLJLLQGLFDWLQJWKHSDUDP
-
HWHUVWRSVÀDVKLQJ$WWKLVSRLQWXVH
P1
(UP) and
P2
(DOWN) to scroll through the possible options for that
parameter.
Press keys
P2
and
P3
(17(5WRVWRUHWKHSDUDPHWHUYDOXHPRGL¿HG:KHQ
P1
and
P3
(ESC) are pressed,
WKHPRGL¿FDWLRQVDUHQRWVDYHG%RWKRSHUDWLRQVHQGWKHSDUDPHWHUSURJUDPPLQJDQGUHWXUQWRWKHPHQXSUH
-
ceding parameter selection. Pressing
P1
and
P3
again will end the program and bring about return to normal
operating mode.