Walter WWS-120B2-K01, Руководство по эксплуатации

Страница: 44 / 132

Before Use
44
EN
Check the product and scope of
delivery
Before Use
WARNING!
Do not use the product in potentially
explosive atmospheres. Use the product
only in ambient temperatures between
10 - 40°C.
Disconnect the product from the power
source before making any settings,
mounting or replacing accessories and
carrying out maintenance.
WARNING!
Risk of suffocation! There is a risk of
suffocation by ingestion or inhalation of
films. Keep the packaging film out of the
reach of children.
• Take the welder 1 and the accessories
carefully out of the packaging.
• Check whether the delivery is complete (see
the chapter "Scope of delivery / Description
of parts").
• Check whether the welder or the accessories
are damaged.
• Do not use the welder if it is damaged or parts
are missing. Contact the manufacturer at the
service address indicated on the warranty
card.
Assemble the face shield
(Fig. A, B, C)
Mounting the strap (Fig. D)
• Insert the two mounting clips 19 from the
front into the face shield 24 .
• Push the protective glass locks 16 from the
inside until it locks onto the mounting clips.
• Turn the locks until the flat side lies on the
inside of the viewer.
Place the light protective glass 20 from the
inside into the face shield.
• Guide the strap 25 through the slot at the
rear of the welder over the housing cover
through the slot on the front of the welder.
• Connect the ends of the belt using the belt
clip.
• You can adjust the length of the strap using
the belt clip
• Place the dark protective glass 21 with the
label facing up on the light protective glass.
• Place the protective glass frame 22 on the
dark protective glass.
• Rotate the protective glass locks by 180° so
that the protective glass unit is held in place
by the semi-circular side of the locks.
• Insert the three knurled screws 17 from the
front into the face shield.
• Place the handle 23 from inside on the
knurled screws.
• Tighten the handle firmly using the three
nuts 18 .
• Press the sides of the face shield toward the
inside and lock the integrated clips into the
corresponding holes.