En
ENGLISH
11
Symbols on the tool:
.......... Class II Construction
V ............. volts
A ............. amperes
Hz ........... hertz
W ............ watts
Ø ............. max. diameter of the accessory
.../min ...... revolutions per minute rpm ......... revolutions per minute
~ ............. alternating current
............ alternating current /direct current n....... rated speed
The "C" and "US" indicators adjacent to the CSA Mark signify that the product has been evaluated to
the applicable CSA and ANSI/ UL Standards, for use in Canada and the U.S., respectively.
4. Overview
See page 2.
1 "Quick"clamping nut
2 Support flange
3 Spindle
4 Spindle locking button
5 Sliding on/off switch *
6 Handle
7 Electronic signal indicator *
8 Thumbwheel for selection of speed *
9 Trigger *
10 Switch-on lock
11 Side handle/ Side handle with vibration damping *
12 Safety cover
13 2-hole nut *
14 2-hole spanner *
15 Lever for safety guard attachment
* depending on equipment/not in scope of delivery
5. Commissioning
Before plugging in, check to see that the rated mains voltage and mains frequency, as stated
on the rating label, match with your power supply.
Always install an RCD/GFCI with a max. trip current of 30 mA upstream.
5.1
Attaching the side handle
Always work with the additional handle attached! (11) Attach the additional handle on the left or right
of the machine and secure.
5.2 Attach the safety guard
For safety reasons, always use the safety guard provided for the respective wheel! See
also chapter10. Accessories!
Safety guard for grinding
Designed for work with roughing wheels, flap sanding pads, diamond cut-off wheels.
See illustration on page 2.
- Push and hold the lever. (15) Place the safety guard in the position indicated. (12)
- Release the lever and turn the safety guard until the lever engages.
