WAHLAP TECH LUMBER JACK, Руководство пользователя

Страница: 47 / 101

7.Remove one screw with the screwdriver, then remove the stop sleeve and buffer rubber.
8.Remove two screws with the screwdriver, then remove the axe handle cushion.
9.Take out the hardware.
10.Make sure to turn it over into the angle in this picture and take out the linear slider to
prevent the balls from falling out.Replace new and install it in reverse order.
Make sure to turn it over into the angle in this
picture and take out the linear slider
Make sure to turn it over into the angle in this
picture and take out the linear slider
When the linear slider is installed in reverse order, make sure
that all screws are coated with the screw glue.
Make sure that the linear slider slides in from an open upward
angle to prevent the balls from falling out; the linear slider
cannot be turned over to continue installation of other parts
until it slides into the linear guardrails completely.
$GMXVWPHQWRIOLPLWVFUHZ
1. Repeat steps 1~5 of section 5.2.22, and remove the axe seat assembly.
2. Adjust the position of limit screw, and make the spring force suitable. Assemble in
reverse order after adjustment.
If the spring force is too large or too small, adjust the position of limit screw according to
the following procedure.