WAHLAP TECH LUMBER JACK, Руководство пользователя

Страница: 51 / 101

5HSODFHPHQWRUUHSDLULQJRIPDLQERDUG
1.Turn off the power, open the lower rear maintenance door with the key, unplug one
connecting terminal, see the components shown as the following figure:
2.Test the operating condition of relevant components and pull out the connecting terminals of
damaged components.
3.Remove four screws that are used to fix the damaged components, then remove the
damaged components.
4.Replace new and install it in reverse order (firstly insert the terminals back according
to the labels and insert the terminals back according to the side of pin seat).
Main-board
FMJ-MainBoard.PCB
DC drive board
FMJ-MotorDrvier.PCB
LED control panel
FMJ-DKQ.PCB
Main-board
（
FMJ-MainBoard.PCB)
Main-board P1
Output and input control lines
Main-board P3
Output and input control lines
Main-board P1
Output and input control lines
Main-board P2
Input control line
Main-board P3
Output and input control lines
Volume adjustment
Fuse 5A/16V
Main board power supply
12V power
Main-board P6
Output control line
Main-board P5
Output control line
S2, No. 3 Schematic diagram for S2
OFF OFF OFF
S2, No. 2 S2, No. 1
S1, No. 3 Schematic diagram for S1
OFF OFF ON
S1, No. 2 S1, No. 1
Small tree electromagnet drive board
FMJ-CH12Magnet.PCB Small tree electromagnet drive board
FMJ-CH12Magnet.PCB
JP
（
Bonus
）
Ticket control U-shaped
photoelectric board XXH-181020A
Slope photoelectric detection board
WL-FMG-EYE-V1.0
JP
（
Bonus
）
Ticket control U-shaped
photoelectric board FMJ-SENSOR.PCB
Slope photoelectric detection board
WL-FMG-EYE-V1.1