Waeco CoolFun CA-35, Инструкция по эксплуатации

Страница: 8 / 16

CoolFun CA-35
9
lid is opened.
➤
Place the cooler on a firm and level
base.
Check the horizontal pos ition (±2˚) with a spirit level if necessary.
➤
Open the lid of the control panel ( 2 1, page 4) by pressing down on it. Press down
on the lid again to close it.
Ensure that the objects placed in the cooler are suitable for cooling to the selected
temperature.
Ensure that food or liquids in glass containers are not excessively refrigerated. Liquids
expand when they freeze and can thus destroy the glass containers.
Connecting to 220 V – 240 V
Check that the voltage specification on the type plate corresponds to that of the
energy supply.
➤
Plug the earthed plug into a properly installed safety plug socket.
➤
Set the thermostat control ( 2 2, page 4) to “MAX”.
➤
Wait until the temperature in the cooler has dropped.
➤
Set the thermostat control ( 2 2, page 4) to the desired temperature range.
➤
To switch off the cooler, set the thermostat control ( 2 2, page 4) to “0” and pull
out the plug.
8
Connecting to 12 V DC
You cannot set the temperature with the thermostat control during battery
operation. The device is simply switched on and starts cooling. Disconnect the
cooler from the battery when the engine is not running as otherwise the battery
will be completely run down.
➤
Make sure that the cable from the battery to the cooler is protected by a fuse (max.
15 A).
➤
Select a cable cross section for the cable between the battery and the socket of the 12 V
voltage supply in accordance with the following table:
Cable length Cable cross section
Up to 2.5m 2.5 mm
2
2.5 m to 4.0 m 4.0 mm
2
➤
Make sure that the thermostat control for 220 V – 240 V operation ( 2 2, page 4) is in the
“0” position.
➤
Insert the plug of the connection cable into the 12 V socket (e.g. cigarette lighter). The polarity
cannot be reversed.
➤
To switch off the cooler, pull the plug out of the socket.