Wacker Neuson DT10, Руководство оператора

Страница: 56 / 120

3-26
BA DT10 en - Edition 1.5 * * dt10b340.fm
Operation
Loading loose material
Caution!
Do not perform any steering movements once the bucket has penetrated the
material.
Lower the loader unit only when the machine is at a standstill and if there is
enough room to the front.
The loader unit is not designed for loading compacted material (hard to
penetrate), serious loader unit damage can occur.
☞
Only load loose material
☞ Lower the loader unit to the ground A
☞ Slide the control lever 1 B forward
Caution!
Do not perform any steering movements once the bucket has penetrated the
material.
Caution!
Load the machine only on firm and level ground!
☞ Drive forward into the material A
If the engine speed decreases due to too much material:
☞ Raise the loader unit a little
☞ Move the control lever 1 D to the rear
Notice!
If the loader unit cannot be raised in the material
• Reduce the load on the loader unit by reversing
Ending loading
☞
Set the loader unit to position C
☞ Move the control lever 1 D to the rear
Fig. 50: Horizontal lowering of the loader unit
1
B
A
Fig. 51: Driving into the material
A
D
1
Fig. 52: Tilt in the loader unit
C
1
D