Wacker Neuson BFS 1345, Руководство оператора

Страница: 11 / 42

Safety information
SV00075en.fm
11
2.4 Maintenance
2.4.1 Only use original spare parts. Alterations to this machine, incl. adjust-
ments of the maximum engine speed set by the manufacturer may only
be carried out with the express permission of Wacker Neuson. In case
of non-observance, all liability shall be refused.
2.4.2 Switch off the motor during maintenance work and remove the spark
plug terminal cap (if there is one), in order to avoid an unintentional
start. This procedure may only be waived if the work cannot be carried
out when the motor is switched off.
2.4.3 Exercise caution when checking the ignition system. The electronic
ignition creates a very high voltage.
2.4.4 As soon as maintenance and repair jobs have been completed, all
safety devices must be properly reinstalled.
2.4.5 It is not permitted to tilt the machine for maintenance work.
2.4.6 In order to prevent malfunctions, the floor saw should be cleaned using
water after each use.
2.5 Transport
2.5.1 Prior to transport, the cutting blade must be removed and the floor saw
must be put in the lowest cutting position.
2.5.2 For the loading and transportation of floor saws with hoisting gear,
suitable sling chains must be secured at the relevant fixing point.
2.5.3 Loading ramps must be able to bear the load and be in a stable
position. Make sure that no one can be endangered if the machine
slips away or tips over, or if machine parts suddenly move upward or
downward.
2.5.4 When floor saws are being transported in vehicles, precautions have
to be taken to ensure that they do not slip and fall over.
2.6 Maintenance checks
2.6.1 According to the conditions and frequency of use, floor saws must be
checked for safe operation at least once a year by skilled technicians,
such as those employed by Wacker Neuson service stations, and
repaired if necessary.
Please observe the appropriate rules and regulations valid in your coun-
try.