Wacker Neuson 9200000150, Руководство по эксплуатации и техническому обслуживанию

Страница: 13 / 19

Page 13 of 19
Item – Rev(s): 9200000150 & 9200000160 – 101
Moving a Non Functioning Machine
The best way to move a non-functioning machine is by forklift or crane. It is also possible to
push or tow a machine slowly over a short distance without the use of the engine if required.
Contact your Authorised Wacker Neuson Dingo Dealer for more information.
Using Cylinder Locks
Important: Normal maintenance should be completed with the load frame fully lowered. If
maintenance or repairs requires the load frame to be raised, use the cylinder lock provided.
Warning: The load frame may lower when in the raised position. To avoid this hazard always
install cylinder locks or safety stand, available through your Authorised Wacker Neuson
Dingo Dealer.
06 – ATTACHMENTS
6.1 Connecting
Use only Genuine Wacker Neuson Dingo attachments. Attachments can change the stability
and operating characteristics of the machine. Use of non-genuine attachments that do not
meet the machine manufacturer specifications may void warranty.
IMPORTANT
Before connecting an attachment to the machine make sure the mount plates are free of
any dirt or debris. Dirt build up in the bottom of the receiver plate will become compacted
and ultimately cause damage.
-
Move pump control switch to slow position.
-
Slowly push the attachment tilt lever forward to tilt the mount plate forward.
- Position the mount plate into the upper fold of the attachments receiver plate.
- Raise the load frame while tilting back the mount plate at the same time.
-
The attachment should be raised enough to clear the ground and the mount plate tilted
all the way up.
- Turn the ignition key to off to stop the engine.
- Engage the attachment lock pins (the lock pins should go down 15mm as they turn).
Note lock pins are located on the outer edge of the mount plate and should be turned
towards the inside to engage.
For hydraulically powered attachments;
- With the engine turned off move the auxiliary hydraulics lever to the forward,
backward, and back to neutral position to relieve hydraulic pressure at the hydraulic
couplers.
- Ensure hydraulic connections and clean on the attachment and machine.
- Remove protective plugs from the hydraulic couplers on the machine and connect them
together to prevent contamination during operation.
- Slide collar back on hydraulic coupler and connect attachment couplers to machine
couplers. There will be two connections to make.
- Confirm that connection is secure by pulling on the hoses.