Wacker Neuson 9200000150, Руководство по эксплуатации и техническому обслуживанию

Страница: 9 / 19

Page 9 of 19
Item – Rev(s): 9200000150 & 9200000160 – 101
05 – OPERATION
Become familiar with this manual and the engine manual.
Before commencing operation each day perform the following pre start checks:
5.1 Operating Instructions
Read all the safety instructions and the pre start section of this manual and the engine
manual before operating the machine.
Do not operate any of the control levers including the auxiliary lever unless you are standing
with both feet on the platform and firmly holding the grip handles.
The auxiliary hydraulic lever must be in the centre (disengaged) position before attempting
to start the engine. The most common cause of reported starting difficulties are a result of
the auxiliary lever being engaged therefore starting the engine while under load.
5.2 Machine
Fuel level; fill to 60mm from the top (do not overfill)
Engine oil level (refer to the engine manual)
Remove all debris from the machine
Check the air filter and clean if necessary
Check the bushes and pins for wear
Check the tyre pressure is 25-30PSI
Check fans and cooling ventilation are clean and clear from obstruction
Check the machine for leaks i.e. oils, fuel, water
Check the machine for any damaged or loose components
Check wheel nuts (85fld/115nm) daily for first 6 days of operation
5.3 Operator
Only those suitably competent and familiar with the machine, the attachments, and the
intended use to may operate the machine.
The operator should wear appropriate clothing and personal protective equipment:
- Fully enclosed non slip footwear (safety boots)
-
Long pants and shirt
-
Safety glasses
- Hard hat if working in areas with a risk of falling items or overhead obstacles
- Hearing protection
Operator is supervised if undergoing training