Wacker Neuson 9200000150, Руководство по эксплуатации и техническому обслуживанию

Страница: 14 / 19

Page 14 of 19
Item – Rev(s): 9200000150 & 9200000160 – 101
6.2 Disconnecting
-
Lower attachment to the ground or onto a trailer.
-
Turn the ignition key off to stop the engine.
- Move the auxiliary hydraulics lever forward, backward and back to neutral position to
relieve hydraulic pressure at the hydraulic couplers.
-
Slide collar back on the hydraulic coupler and disconnect attachment couplers from
machine couplers (Note if this is difficult return to and repeat the 3
rd
step).
- Connect attachment hoses together to prevent contamination during storage.
- Install protective cover onto the Machines hydraulic couplers.
-
Disengage the attachment lock pins by turning them to the outside.
-
Start the engine, tilt the mount plate forward and back machine away from the
attachment.
07 – TRANSPORT
Always observe and adhere to applicable local, state, and federal legislation and regulations.
When loading/unloading on a trailer, always follow these instructions:
- Never load or unload a machine on a trailer unless the trailer is attached to the vehicle.
-
Always climb the ramps with the heavy end of the machine up hill.
-
Attachments should always be secured in their designated positions on the trailer with
suitable load restraint equipment to assist correct weight distribution.
- Ensure the entire load is positioned for correct weight distribution and load over the
tow hitch in accordance with the tow vehicle manufacturers recommendations.
- Once in position on the trailer lower the load frame
- Turn the key to off to stop the engine.
-
Remove the key.
-
Secure the machine at the designated tie down points to the trailer with suitable load
restraint equipment.