MIO-R290GM2011 Rev E
G&B Specialties Inc. 535 West 3
rd
Street, Berwick, PA, USA Tel: (570) 752-5901 Fax: (570) 752-6397
US Field Service: 570-441-6988; CAN Field Service 570-854-0482; www.rafna.com
-90-
I
NSTALLATION OF
R
EAR
R
AILGEAR
R
OD
L
OCK
K
IT
The following procedure details the installation of the rear railgear kit as it pertains to the Rear
Railgear Rod Actuated Lock. The hardware required for one front installation is listed in table 1.
Table 1: Railgear Kit Installation Parts
Part Number
Description
Qty
R-2900LR Rear Railgear Assembly, Lever Lock
REF
R-1600 Rail
Wheel
Assembly
REF
R-21102D Rail
Sweep
REF
R-21102P Rail
Sweep
REF
K-R29ARRXR290R Lever
Lock
Kit
1
The components of the Rear Rod Lock Kit are listed in Table 2 below.
Table 2: K-R29ARRXR290R - Rear Rod Lock Kit
Part Number
Description
Qty
P-00031
Push Rod, Lower
1
P-00032
Push Rod, Upper
1
P-00023 Lock
Pin
1
R-3561 Spring
(pre-assembled)
1
P-00024 Tie
Plate
1
R-5652A Knob
1
P-00034
Support Plate, Upper Rod
1
R-990KIT-279 Installation
Hardware
Kit
1
1.
Refer to the Railgear Kit installation manual that was shipped with this Railgear Unit for
installation procedures.
2.
The Rear Railgear Unit is shipped with the rod lock partially assembled. The remaining
components are shipped loose with the railgear unit and will need to be installed at railgear
installation.
3.
Once the railgear is installed at the correct mounting height, assemble the lower push rod to
the upper push rod with the supplied tie plate. Locate and adjust the upper push rod as
necessary.
4.
The upper push rod may cut to length or otherwise modified by the installer as required to
work with the individual vehicle installation.
5.
Locate and install the upper rod support plate as necessary. Due to the length of the upper
rod it is necessary to support the end of the rod to ensure proper operation. If the supplied
support plate is not suitable, a proper support plate will need to be supplied by the installer.