WABECO CC-D6200 hs, Руководство по эксплуатации

Страница: 31 / 55

31
14. Operational faults and the elimination of such
Operational faults Possible cause Remedy
Machine cannot be switched on 230V voltage is not present Plug is not fitted correctly
Check the fuse for the socket
Emergency off switch not
unlocked
Unlock the emergency off
switch
Main spindle motor no longer
starts after the unlocking of the
emergency off switch
Motor controller must be unlocked Wait approx. 5 seconds after
unlocking the emergency
ON/OFF switch before
reactivating machine with
ON/OFF switch.
Also the manual operating field
of the software has to be
closed and the machine must
be reloaded.
Tool skid cannot be moved or
can only be moved with
considerable force
Clamping of the tool skid is on Open the clamping
Guide play is set too narrowly Adapt the guide play
Transverse cannot be moved or
can only be moved with
considerable force
Guide play is set too narrowly Adapt the guide play
Rust on work pieces of machine
parts when using coolant
lubrication
Wrong coolant set Check the mixing ratio of the
coolant and correct if required
(never cool with water alone!)
Tool holder cannot be inserted
into the main spindle (reducing
sleeve of the main spindle)
An incorrect tool taper of the tool
holder has been used in
combination with the reducing
sleeve
Only use the appropriate tool
holders for the machine
Inner cone of the reducing sleeve
or outer cone of the tool holder is
contaminated
Clean the relevant cone
Doors of the safety cabin
cannot be opened
Machine is not switched off and/or
switch for operating modes in zero
position
Machine switched of, switch
for operating modes on CNC
operation of set-up mode
Main spindle is running Main spindles stops