WABECO CC-D6200 hs, Руководство по эксплуатации

Страница: 24 / 55

24
7. Maintenance
A long lifetime of the machine will depend on the appropriate care and maintenance.
■ All maintenance and repair tasks may only be carried out with the grounded plug pulled.
■ The machine must be cleaned after each use.
■ If the machine is set up in a wet room, all exposed parts must be oiled after each use to prevent
corrosion.
■ Always lubricate all moving parts well.
■ In the event of bearing or skid play, immediately adjust in order to prevent it from destroying the
bearing or skid guide.
Approximately every 100 operating hours
■ Check the tension of the poly V and gear belt and adjust if necessary.
■
Check the play in the guides and feed spindles and set if necessary.
8. Lubrication of the machine
The lubrication process:
■ Reduces wear and friction
■
Increases the lifetime
■ The metal surface are protected from corrosion
We recommend :
■ A class 2NLGI multi-purpose grease for lubrication
■ A lubrication oil with a viscosity of 100 mm
2
/s for oiling
The lathe is to be lubricated every 8 hours of operation in accordance with the lubrication plan. The
lubrication points.
■ Bed guide
■ Dovetail guide cross slide
■ Dovetail guide traverse slide
■ Tailstock sleeve
Are lubricated with the help of an oil can and an ordinary lubrication oil by moving the skid or sleeve
backwards and forwards.
All other lubrication points are lubricated with a grease press at the designated lubrication nipples.
1
Every 8 hours of operation
2
Every 8 hours of operation