W6 N 8000, Инструкция по эксплуатации

Страница: 10 / 64

8
CHANGING THE PRESSER
FOOT
The presser foot must be changed according
to the stitch you sew, or work you do.
CAUTION: To prevent accidents.
Turn off the power switch before you change
the presser foot.
A. Changing the presser foot
1. Turn the hand wheel toward you until the
needle is at its highest point.
2. Raise the presser foot lifter.
3. Remove the presser foot by pushing the
presser foot release lever toward you.
4. Place desired foot with its pin directly
under the slot in presser foot holder.
5. Lower the presser foot lifting lever and the
presser foot will snap into place.
B. Removing the presser foot holder
When cleaning around the feed dog or
attaching extra foot (option), you may remove
the presser foot holder.
1. Remove the presser foot.
2. Loosen the presser foot thumb screw and
remove the presser foot holder.
3. To replace the holder, pull up the holder
as far as it will go from bottom of presser
bar.
4. Tighten the thumb screw.
DUST COVER
Cover the machine with dust cover
when it is not to be used.
CAUTION:
Always remove the roupe if attached to the
machine.
You can store this manual by opening the lid
(a).
Do not remove the cushion located inside of
the cover.
a