W6 N 8000, Инструкция по эксплуатации

Страница: 8 / 64

6
CONNECTING THE MACHINE
FOOT CONTROLLER
Use of foot controller will permit control of start, stop and speed with your foot.
When the foot controller is connected, start/stop button will be disactivated. (See page 10)
DANGER: To reduce the risk of
electric shock.
Never leave unattended when plugged in.
Always unplug this machine from the electric
outlet immediately after using and before
maintenance.
WARNING: To reduce the risk of burns,
fire, electric shock, or injury to persons.
Do not unplug by pulling on cord. To unplug,
grasp the plug, not the cord.
1. Place machine on stable table.
2. Connect the power line cord to the machine
by inserting the 2-hole plug into the terminal
box.
3. Connect the power line plug to the electric
outlet.
4. Turn on the power switch.
5. A lamp will light up when switch is turned
on.
6. To disconnect, turn the power switch to the
off position (symbol O ), then remove plug
from outlet.
1. Turn off the power switch. (symbol O )
2. Push foot controller plug into the jack on
machine.
3. Place foot controller at your feet.
4. Turn on the power switch.
5. A lamp will light up when switch is turned
on.
6. The harder you press the foot controller,
the faster the machine will sew. The
machine will stop when foot controller is
released.
WARNING: To reduce the risk of burns,
fire, electric shock, or injury to persons.
1. Turn off the power when connecting the
foot controller to the machine.
2. Handle the foot controller with care and
avoid dropping it on the floor. Be sure not
to place anything on top of it.
3. Use only foot controller provided with this
machine. (Type 4C-337B)