W6 N 8000, Инструкция по эксплуатации

Страница: 46 / 64

44
1
DARNING/FREE-HAND
EMBROIDERY
No. 1 Darning/Embroidery Foot
A. ATTACHING THE DARNING/
EMBROIDERY FOOT
1. Lower the feed dogs by moving the drop
feed lever to the left.
2. Remove the presser foot and holder.
3. The arm of darning/embroidery foot
should ride onto the shaft of the needle
clamp screw.
4. Slide the plastic attaching head from
your left to right so that it is fitted into the
presser bar.
5. Tighten the presser foot thumb screw.
B. DARNING
1. Place fabric under foot and lower it.
2. Grasp fabric firmly in front and back of
area to be darned. Operate machine,
moving fabric by hand forward and
backward with an even motion, stitching
in closely spaced rows over the hole or
worn area.
3. When the area is filled with new stitches,
move fabric from side to side in a similar
manner to weave or reinforce the
stitching.
a. Note:
Reinforce open areas with an underlay,
baste undelay in place before darning.
C. FREE-HAND EMBROIDERY
1. Outline the design for embroidery on the
surface of the fabric.
2. Place design to be embroidered between
the two sections of embroidery hoop.
Note:
Embroidery hoop is not included with this
machine.
3. Set embroidery hoop under needle and
lower the foot.
4. Start the machine at medium speed,
guiding hoop carefully so needle moves
along line of the pattern.
D. After darning or free-hand embroidery
Raise the feed degs by moving the drop
feed lever to the right.