Provisioning Using Configuration Files
89
Back to Contents
VSP725 Administrator and Provisioning Manual
See
“Configuration File Parameter Guide” on page 95
for the options and value ranges
available for each configuration file setting.
Resynchronization: configuration file checking
You can select a number of options that determine when the VSP725 checks for new
configuration files. This process of checking for configuration files is called
Resynchronization. Resynchronization options are available on the WebUI
Provisioning
page, but you can also include them in a configuration file.
The resynchronization options are:
Mode—sets the VSP725 to check for a configuration file only, a firmware update
file only, or both types of file.
Never—configuration file checking is disabled
Bootup—the VSP725 checks for new configuration files when it boots up. Any
updates are applied during the boot-up process.
Remote check-sync—enables you to start a resynchronization remotely using your
hosted server's web portal. The Remote check-sync settings are available only in
the configuration file, not the WebUI.
Repeatedly, at a defined interval from 60 to 65535 minutes (45 days).
VSP725 restart
If the VSP725 needs to restart after an auto-update, the restart happens only after the
device has been idle for one minute.
To prevent users from delaying the update process (auto-updates cannot begin until the
VSP725 has been idle for one minute), or to avoid device restarts that might interfere with
incoming calls:
set the resynchronization interval to a suitable period
upload any new configuration file(s) to your provisioning server after work hours so
that the VSP725 will download the file(s) when there is no call activity.
When you update the VSP725 by importing a configuration file using the WebUI, the device
restarts immediately after applying the new settings, regardless of whether the VSP725 is
idle.
