Using the WebUI
58
Back to Contents
VSP725 Administrator and Provisioning Manual
Paging Zone
On the Paging Zone page, you can enter the multicast IP addresses that the phone will
monitor. When a page is sent out using this multicast IP address, all phones that are
programmed to monitor that IP address will receive the paging RTP stream and play the
page on their speakerphone. You can also enable the phone to send out multicast pages
using a particular multicast IP address.
You must first set up paging groups (each group consisting of a multicast paging IP address
and assigned User IDs) on your SIP PBX. The VSP725 can monitor a maximum of 10
multicast IP addresses.
Setting
Description
Name
Enter the name of the paging zone. Names can be a
maximum of 15 characters. The paging zone name is
displayed on the LCD during incoming and outgoing
multicast pages.
Multicast IP
Enter the paging zone multicast IP address. The IP
address range for multicast addresses is
224.0.0.0–239.255.255.255.
Multicast Port
Enter the multicast port used by the multicast IP address.
The valid port range is 1 to 65535.
Priority
Select the paging zone priority from 1 to 10. Zones with a
priority higher than another zone can interrupt the
lower-priority zone's active page.
In addition, a call priority setting is available in the
configuration file (page_zone.call_priority_threshold). This
priority setting also ranges from 1 to 10 (2 is the default). If
the paging zone priority is higher or equal to the call
priority, then a multicast page can interrupt an active,
dialing, or incoming call.
Enable Incoming Page
Select to enable the VSP725 to receive incoming pages for
that paging zone. If the "Enable Incoming Page" checkbox
is not selected, the phone will not listen for the multicast,
but will still be able to broadcast an outgoing page.
