--4--
Option: 2. (Auxiliary) Output „Battery II“ 12 V
/
2 A (24 V
/
2 A):
That charging output is provided for support charging and conservation of charge of the
vehicles' starter battery
in
case of extended stop periods and for compensation of the charge for e. g. short-term consumers (interior lighting of
the driver's cabin etc.). The LED
„ Battery II “
is lighting, which indicates the readiness for service and control of
that output.
The output voltage of this output is slightly lower than the output voltage of the main output, and its current and
output voltage is limited in such a way, that overcharging of the vehicle’s starter battery can be excluded.
The auxiliary charging output of battery II may be used or not used, the function of the main
output battery I will not be affected, except that the current rate is reduced by the inferior
current rate of battery II.
Option: Remote Control
(Tip Jack „Remote Control“)
If the charger has been installed at a difficultly accessible location, the
Remote Control
for Automatic Charger SMT (Order No. 3129)
can be used for remote control of the
charging process (connection cable of a length of 5 m being ready for connection is
included in the delivery scope).
Connection:
Just insert the plug of the remote control into the tip jack "Remote Control" of the
charger.
Functioning:
The remote control is equipped with the same pilot lamps (light-emitting diodes) as the
charger.
Switch Function
(also refer to paragraph Switch „Silent Run“):
Position „ON“: Charger works with full charging capacity.
Position „OFF“: Ensures silent operation on board by means of the function “silent run “, noise optimised operation
(Night Operation), see below
Key
„Silent
Run“
, noise optimised operation (night operation):
Press the key for a short moment for activation:
The internal cooling fan of the unit will be set to constant low noise, steady speed.
Any light-emitting diodes will be switched off, only the current display „Current“ will still be lighting
weakly.
Of course, any charging and control functions continue working internally to the full extent
The reduced cooling capacity might reduce the charging capacity to approx. 80 %, depending on the
ambient temperature of the charger.
Reactivation of the display and thus of always the full charging capacity:
Possible at any time by manual pressing the key again
Automatic reactivation after 10 hours by integrated timer (end of nighttimes) and thus back to full charging
capacity
Further actions or maintenance of the unit are not required.
