Assembly instructions VOSSOBW501
SG sensor
, Page 12 of 22
2. Assembly of VOSS OBW 501
SG sensor
Before using the VOSSOBW 501
SG sensor
, components must be checked. They have to be clean and
must not show any signs of damage.
To make sure the sensor can measure correctly, the surface has to be flat, clean and completely free
from dirt, paint, dust, oil and grease (see chapter “C. Assembly instructions, 1. Grinding and cleaning
of surfaces”).
Provide the following materials/tools: scriber, adhesive Panacol GTH-T with two-part adhesive
applicator, an adhesive and sealing compound (CARSYSTEM
®
UNIFLEX PU with single part cartridge
press is recommended, or comparable products), spray paint (with corrosion protection; varies
depending on individual vehicle) and cable ties.
Use new, clean gloves, while working with mentioned chemicals. Prepare yourself with further personal
protective equipment, if needed according to local regulations.
Step 1
Mark at the edges center position of prepared surface for
sensor with scriber.
Do not use pencil or pen. Surface will not be clean
anymore.
Do not contaminate the cleaned surface.
Fig. 21: Marking center position
Step 2
Carefully place the sensor on the center position of the
cleaned surface.
Do not contaminate the cleaned surface and the
sensor.
Fig. 22: Placing the sensor on the cleaned surface
!
!
!
!
!
!
!