Vortex-RC VT-AllRounder, Инструкция пользователя

Страница: 16 / 35

Prepare the Fuselage top by glueing in the Servo doubler in place. Place the Fuse top as shown
below and glue in the doubler in place. The Servo cutout is on the LEFT side of the fuselage, but the
doubler is glued to the inside surface, so when you glue in the cutout should be on the right side as
shown below.
Align the Fuselage top with all of the formers and Fuse sides carefully. Be sure the coro is not
crushed or damaged and that each notch fits properly. When satisfied, flow a few drops of CA over
each joint. Hold in place to ensure a good, tight bond is made.
​
Install the stabilizer .
​
It is very important to glue in the
Horizontal and Vertical stabilizers square and true. Take
your time to align these parts properly before adding glue.
Use the Supplied Pin and thread to ensure that the Stabiliser
is perfectly centered as shown below.
Without using any glue, slide the rudder through the notch
in the stabilizer. and carefully install the stabilizer in place.
The notches help align the parts accurately, and the rudder
goes all the way through the stabilizer down to the base of the fuselage. You also
need to measure the distance from the nose, to the tip of the stabilizer using the pin
and thread to make sure the distances are equal. Adjust till satisfied, and then
without moving anything, add glue and give it a few minutes to bond securely.
www.Vortex-RC.com ​ 16