background image

Specifications:

 

Length: 23.75”

 

Diameter 2.6”

 

Weight: 14oz

 

Recovery: 24” Nylon Chute

 

Motor Mount: 29mm

 

Fins: 4 – 1/8” Plywood

 

CG: 15.5” from nose tip

Recommended Motors:

 Single 

Use  RMS

  F20W-4 950’   F40W-7 1140’

 F23FJ-4 

800’ 

 F52T-5 

1060’

 

F25W-6  1100’ 

G64W-7 1600’

 

F26FJ-6 950’ 

  F50T-6 1040’ 

 

G40W-7 1420’

  G80T-7 1400’   

 

Parts List

 

1.  (1) Molded nose cone

 

2.  (1) pre-slotted body tube

 

3.  (2) Centering rings

 

4.  (1) 29mm motor tube

 

5.  (4) laser-cut fins

 

6.  (1) Kevlar® shock cord section

 

7.  (1) Nylon shock cord section

 

8.  (1) 9”x9” flameproof chute protector

 

9.  (1) 24” Nylon chute

 

10.  (2) ¼” launch lugs

Required to complete

:  5 minute epoxy, 

120/220 sandpaper, masking tape, finishing 

filler/paint, lead shot for nose weight.

8

98666 00100

0

K-100

®

Содержание Momba K-100

Страница 1: ...600 F26FJ 6 950 F50T 6 1040 G40W 7 1420 G80T 7 1400 Parts List 1 1 Molded nose cone 2 1 pre slotted body tube 3 2 Centering rings 4 1 29mm motor tube 5 4 laser cut fins 6 1 Kevlar shock cord section 7 1 Nylon shock cord section 8 1 9 x9 flameproof chute protector 9 1 24 Nylon chute 10 2 launch lugs Required to complete 5 minute epoxy 120 220 sandpaper masking tape finishing filler paint lead shot ...

Страница 2: ...or tube and slide the forward ring with the notch until it aligns with the mark Step 2 Shock Cord Attachment The shock cord in this kit consists of a shorter section of Kevlar and a longer section of nylon cording The two sections should be tied together using a single overhand ring bend or double fisherman s knot The Kevlar section will be attached to the motor mount and the nylon section will be...

Страница 3: ... body tube before sliding the rear centering ring into the body tube Continue sliding the assembly inside the body tube until the aft end of the motor tube is even with the aft end of the body tube It s a good idea to test fit a fin in each slot here before the epoxy sets Hold the body tube with the motor tube assembly down until the epoxy sets Make sure the weight of the motor assembly doesn t ca...

Страница 4: ...emember that rockets are not toys and can be dangerous if not prepared and used properly If you are a beginner it is a good idea to fly with a club or other group of experienced rocketeers until you have gained some experience IMPORTANT In no event shall Madcow Rocketry be liable for any direct indirect punitive incidental special consequential damages whatsoever arising out of or connected with t...

Отзывы: