Volvo Penta D1 Series, Руководство оператора

Страница: 30 / 92

Settings
Language
: setting the display language.
Bleep : setting button bleep On or Off.
Engine : setting the installation the display forms part
of, and the engine to be shown in the display (single,
port, starboard or twin).
Eng. series : setting the engine series for the display
(D1/D2, <D2). The display is factory set for engines
larger than D1/D2, therefore the display must be re-set
before it can be used on D1/D2 engines.
Display : setting speed indicator and tachometer
intervals.
- Rpm intervals, 2500–9000 rpm in 500 rpm stages.
Set 4000 rpm.
- Speed, on/off.
- Speed intervals, 10–100 knots in 10 knot stages.
- Graph intervals: 2 min, 10 min, 30 min, 60 min, 2 h,
4 h or 8 h.
- Speed (Speed): KNOTS, MPH, KM/H
Units : Selection of operational information units to be
shown (this menu is only displayed if “Local” is selected
in the settings menu: “Local” must always be selected
for D1/D2 engines).
- Distance: NM, MILE, KM
- Oil pressure/Turbo pressure: kPa, psi
- Fuel rate: L/H, GAL/H, IGAL/H
- Temperature: °C, °F
Calibration : the engine must be switched on during
calibration.
Depth compensation
Setting the Volvo Penta echo sounder. The echo-
sounder can be installed anywhere between the
waterline and the boat's deepest point. Set the
deviation – off set – so that the display value shows
one of these points.
To adjust the value up (+), set the distance between
the echo-sounder and the waterline; to adjust the value
down (–), set the distance between the echo-sounder
and the boat's deepest point. The value can be set in
0.1 unit stages.
Store the set value by depressing BACK (button 5).
P0003002
Instruments and Controls
28 47711262 01-2019 © AB VOLVO PENTA