Volvo Penta AQ125A, Руководство по ремонту

Страница: 41 / 74

39
119. Fit the intermediate shaft seal with tool 999 5025.
NOTE! Lubricate the seal’s rubber lip before fit-
ting. Alter the sealing ring’s position in relation to
its earlier position so that a new contact surface
against the shaft is obtained. Be careful when fit-
ting the seal.
120. Paint mineral grease or similar grease in the
flywheel’s hub and replace the flywheel and the
guide plate on the camshaft. The flywheel’s
groove is to be fixed on the guide pin on the
camshaft. NOTE! The guide plate’s bend is to
point backwards (against the seal).
121. Fit the screw, the guide plate and the washer and
tighten it with a torque wrench. Use tool 999 5034
as a counterforce. The tightening torque is 50 Nm
(5.0 kpm). (36.9 lbf. ft.).
122. Paint mineral grease or similar lubricant in the
pulley’s hub and fit it in position on the intermedi-
ate shaft. Fit the screw and tighten it with a torque
wrench.
The tightening torque is 50 Nm (5.0 kpm) (36.9
lbf. ft.). Use tool 999 5034 as a counterforce. Then
refit the cross piece.