V
OLTECH
AC
I
NTERFACE
U
SER
M
ANUAL
98-072
ISS
7
PAGE
32
If you see warning messages on the front panel display of the AT3600/AT5600 (see the safety section of this
manual), it is likely that high voltage is present. Do not touch the fixture. Follow the instructions given on the
panel. The source controls are not working properly, and you should investigate.
Other errors may be reported by the Editor because the source has not switched on at all, has switched on
at the wrong voltage, or the voltage sense leads are not connected.
Check all connections, the gain settings for the source configuration in the PC Editor and that the fixture
wiring is the same as that described in the Editor.
Only after performing a successful 'no load' test should you attempt to test parts.
If errors occur during testing, check as above but make sure that the source (including the transformer type)
can provide the voltage, current and frequency that you expect.
