43
• “CLr” appears in the top of the display. Press the “SET” (1) button briefly, “CLr ALL dATA”
appears at the bottom of the display.
• Use the “
” (4) and “
” (5) button to select one of the two delete functions “CLr
USEr SEt” or “CLr ALL dATA”.
At the beginning of section g) is described which information will be cleared.
• To delete the data (either “CLr USEr Set” or “CLr ALL dATA”) hold the “C” button (2)
pressed for 3 seconds until you can hear a beep. The selected data are deleted. “CLR”
appears on the display.
If you want to interrupt the delete mode without deleting data, briefly press the “SET”
button (1). “CLR” appears on the display.
• By pressing the “
” button (5) briefly, you can return to the beginning of the set-up mode
(setting the time, chapter 8. c).
If you want to close the set-up mode, hold the “SET” button (1) pressed for 3 seconds
(or do not press a button for one minute).
h) Background light
When the measuring device is connected to the mains voltage, the background light is
switched on automatically when a button is pressed.
The background light is switched off automatically if no button is pressed for a duration of
approx. 15 seconds.
i) Resetting the measuring device
If unintelligible characters are shown in the display, you can reset the measuring device.
To do this, press the countersunk “RESET” button (3) e.g. with a finger nail.
Subsequently, you must set the time again, see chapter 8. c).
The recorded data are also lost after a reset. However, the other settings (electricity
tariff, CO
2
emission, overload alarm) remain.
