Vollrath Stoelting CC101A, Руководство оператора

Страница: 10 / 39

Page 5
A. System Startup
1. Verify that the flow control knob, the refrigeration,
and beater switches are in the “OFF” positions.
2. Turn on the Hopper Refrigeration.
3. Pour mix into the hopper pan. (Note: If using rerun
mix, use at least 50% fresh mix to 50% rerun mix.)
4. Turn the beater switch “ON”.
5. Turn the flow control knob to the number “1 1/2”
for approximately 3 seconds. Turn the knob back to
the “OFF” position. This allows custard to mix to
flush the sanitizer from the barrel to avoid instant
freezing of the sanitizer in the barrel.
6. Place the custard slide on the threaded stud beneath
the front plate and secure firmly with a wing nut.
Aim the custard slide into a dipping cabinet or
other suitable container for dipping.
7. Open the front gate.
8. Within several seconds, a few
ounces of liquid mix and sanitizer
will flow out of the custard outlet
and into the dipping well. Discard
this mix.
9. Turn the refrigeration switch on and wait approxi-
mately 2 minutes for a chatter noise.
10. Set the flow control
know to “1/2-1” posi-
tion until frozen cus-
tard is seen at the cus-
tard outlet. Increase
the mix by turning the
flow control knob to
gain the desired cus-
tard texture.
Note: If a “growling” noise comes from the machine
during this procedure, it may be an indication that
there is not enough mix entering the barrel. In-
crease the flow slightly by adjusting the flow control
knob on the front of the machine. Keep in mind that
there are several minutes lag time between the in-
creased mix flow and the elimination of any
“growling” noises
.
11. Continue to run the mix into the bucket until it
reaches the desired quantity.
B. Hold Cycle During Operation
1. Adjust the flow control knob to the “OFF” position.
Wait approximately 1 minute.
2. Turn the refrigeration switch to the “Hold”.
3. When the frozen custard stops flowing, turn the
beater switch to the “OFF” position and REMOVE
KEY. Note: This should take approximately 2 min-
utes.
4. Clean out excess frozen custard from the custard
outlet on the front plate to prevent dripping.
5. Replace key.
6. Close the front gate.
7. Remove custard slide.
C. Resuming Production During Operation
1. Turn the beater switch “ON”.
2. Turn the refrigeration switch “ON”.
3. Wait for a chatter noise, approximately 1 minute.
Turn the flow control knob to the number “1-1 1/2”
position.
4. Open the front gate completely.
5. When the custard appears, adjust
the flow control knob to gain the
desired custard texture.
6. Continue to run the mix into the dipping cabinet
until you have the amount that you need.
Machine Operation