Note
Special tool is supplied with combination sensor.
– Push supplied special tool -1- onto combination sensor -2-.
– Place combination sensor -2- with special tool -1- on heat ex‐
changer.
– When doing this, special tool -1- slides onto heat exchanger
until combination sensor -2- makes contact with collar (instal‐
lation position of combination sensor).
– Engage retaining bracket -3-.
– Pull off special tool -1-.
Note
♦
The combination sensor -2- must sit “flat” on the heat exchanger.
♦
Use a tool to check if necessary, e.g. a torch or a mirror.
Transporter 2016 ➤
Auxiliary heater - Edition 04.2020
54
Rep. gr.82 - Supplementary heating
