Vogt TUBE-ICE P-118F, Руководство по обслуживанию

Страница: 63 / 115

P118F Service Manual
TROUBLESHOOTING
1/6/09
8-3
SYMPTOM: Machine won't run (CONT.)
POSSIBLE CAUSE POSSIBLE REMEDY
Low oil pressure switch tripped. If the machine stops by low oil pressure cut-
out, the switch will have to be manually reset.
Check the crankcase oil level. Restart the
machine by pushing the "Start" push button.
Check the oil level and net oil pressure ( net
oil pressure = pressure reading at the oil pump
end bearing housing minus suction pressure ).
The oil level should be 1/4 - 3/4 level in the
glass. If above 3/4, drain some oil out. See
page 9-9, Section 9 (Oil Pressure Sensor ).
Cutter motor overload tripped. Check and clear the cutter area and ice
discharge path of all ice. Check voltage and
overload range adjustment against motor
rating. Reset the switch and restart the
machine by the "START" push button. Check
the cutter operation and motor amp draw. If
tripping repeats, but ice is not jammed, check
the cutter bearing for wear, the gear reducer
for resistance, and the motor for defect or
single phasing.
Pump motor overload tripped. Check voltage and overload range adjustment
against motor rating. Reset the switch, set the
"Ice/Clean" switch to the "Clean" position
and restart the machine by the "Start" push
button. Check the pump operation and motor
amps. If tripping repeats, check for a
defective overload, defective motor, or single
phasing.
Bin thermostat or bin level control stops
machine. Adjust or replace the bin stat or level control.
Make sure bin stat bulb or level control is
located properly in the bin. See FIGURE 3-7,
Section 3 (Bin Thermostat).
Defective control panel component such as,
PF, BC, CMS PB1, FU-1, FU-2 , T, Etc. See FIGURE 6-2, Section 6 (Wiring
Schematic). Check for open circuit. Refer to
FIGURE 6-1, Section 6 (Control Panel) to
identify parts. Replace defective part, restart
machine and check power supply and current
draw.