Vogelzang International THE RANCHER SR57E, Руководство пользователя

Страница: 4 / 20

4
Refer to diagram and parts lists at back of this manual. Refer to diagram and parts lists at back of this manual.
1. Uncrate the stove and remove cardboard packing and protective poly bag. (Save cardboard for further
assembly.)
2. Remove parts from inside of stove. Parts include: four lids (#1), three lid supports (#4 & #5), one ash door
(#14), one lid lifter (#16), four legs (#15), hardware pack (#17), and Spring Handle (#12) and draft damper
(#18).
3. Place flattened carton on floor and carefully turn stove over onto carton.
4. Attach the legs to base of stove with stove bolts.
5. Carefully lift stove upright and place in desired location (see following instructions for properly locating stove).
6. Place lid supports and four lids in position on stove top.
7. Lower ash door into position.
8. The flue pipe draft damper (#18) must be installed into the top end of the first straight section of stove pipe
(figure1) exiting the stove before the stove is used.
a. Drill two 1/4” holes centered on either side of the pipe section 6” from the top end of the pipe Remove
the handle from the damper then slide the damper into the pipe.
b. Align the damper with the holes drilled in step 8a and insert the handle through the holes and the
damper.
9. Attach stove piping — see instructions.
NOTICE: Vogelzang International Corp. grants no warranty, stated or implied, for the installation or
maintenance of your coal stove and assumes no responsibility of any incidental or consequential damages.
Tools Required
• Safety Glasses
• Hearth Gloves
• Pencil
• 6 foot Folding Rule or
Tape Measure
• Tin Snips
• Drill: Hand or Electric
1/8” dia. Drill Bit (sheet
metal screws)
• Screwdrivers (blade
and phillips types)
• 13mm Nut Driver or
Ratchet with 13mm
Socket (for 13mm Hex
Nuts)
• 13mm Nut Driver or
Ratchet with 13mm
Socket (for Stove Bolts)
Materials Required
• Flooring Protection:
56˝ x 59˝ as specified
Chimney Connection:
6˝ black steel (24 ga.
min.) straight or elbow
(as required)
• 1/2˝ Sheet Metal
Screws
• Chimney: Existing 6˝
Code-approved,
• Lined Masonry
Chimney or 6˝ Inside
Dia. manufactured
chimney system listed
to UL 103 HT.
• Furnace Cement
(manufacturer
recommends Rutland
Code 78 or equivalent)
ASSEMBLY INSTRUCTIONS
CAUTION: Stove is heavy. Make sure you
have adequate help and use proper lifting
techniques whenever moving stove.
NOTE: This damper is necessary for the proper operation of the stove and to meet EPA emissions requirements
for heating appliances. It must be installed before use. (No exceptions)
6"/15.25 cm
Draft Damper
Installation