Vogelzang International THE RANCHER SR57E, Руководство пользователя

Страница: 6 / 20

6
1. The smooth end of the stove-pipe fits over the cast iron
flue collar at top rear of stove.
a. Crimped end of pipe must be away from stove.
b. Hand form lower end of stove pipe to oval shape
and slide over flue outlet collar as shown.
c. Secure stove pipe to flue collar with at least three (3)
sheet metal screws and seal with stove cement.
2. Horizontal pipe runs must slope upwards towards the
chimney at least 1/4” per foot of horizontal run.
3. You must have at least 18 inches of clearance between
any horizontal piping and the ceiling.
4. The pipe cannot extend into the chimney flue.
5. Secure pipe/elbow sections with three (3) sheet metal
screws at each joint to make the piping rigid. Secure
pipe/elbow sections with a minimum of three (3) equally
spaced sheet metal screws at each joint and at the
stove collar to make the pipe rigid.
6. It is recommended that no more than two (2) 90 degree
bends be used in the stove-pipe installation. The use
of more than two 90 degree bends may decrease the
amount of draw and possibly cause smoke spillage.
Where possible, use only corrugated (non-adjustable)
elbows. These provide a better seal.
7. The connector pipe must not pass through an attic or
roof space, trusses, closet, or any concealed space,
or floor, ceiling, wall or combustible construction. (See
Chimney Connector Systems & Clearances) A UL 103
HT listed chimney system must be used from the first
penetration of ceiling or wall to the chimney cap. Use
chimney components from a single manufacturer. Do
not mix brands.
CONNECTOR PIPE INSTALLATION
CORRECT WRONG WRONG
Stovepipe/Flue Connections
Hand-form pipe to oval shape
Flue Outlet Collar
CORRECT WRONG WRONG
Stovepipe/Flue Connections
Hand-form pipe to oval shape
Flue Outlet Collar
CORRECT WRONG WRONG
Stovepipe/Flue Connections
Hand-form pipe to oval shape
Flue Outlet Collar
NOTE: Connector pipe is not included. To purchase pipe,
visit your local Hardware, home or building center. See
“locating stove” for Additional specifications.
WARNING: Do not use single wall
connector Pipe as a chimney - a house fire
Could result.
CAUTION: Keep furnishings and other
combustible materials away from the
stove.