Vodavi Starplus STSe, Быстрый старт

Страница: 9 / 72

STSe Quick Start Guide September 2005
- 5 -
VO D AVI
PROGRAMMING (cont’d)
f. To program CO Line Ringing, press Flexible Button 10 (Page A).
Display shows DDDR:
DDD = number ( example: Station 100 ; Voicemail 440)
R = Ringing mode
1=Day 2=Night 3=Day Night 4=Special 5=Day Special
6=Night Special 7=All times 0=Remove ringing
NOTE
: Phone must ring on incoming CO calls to receive Caller ID information.
Normal setup is S100D = Station 100 rings Day (100 1 HOLD)
V440N = Voicemail ring Night (440 2 HOLD)
g. Always check ringing Flexible Button 13. Change ringing, programming Flexible Button 10,
then check ringing display Flexible Button 13 again to ensure data is correct.
h. To program CO lines to go to the Auto Attendant if not answered by Operator (Station 100),
press Flexible Button 20. Display now shows Page “B”.
i. Press Flexible Button 5 (Pre-set Fwd Day Dest). Enter 440 and press HOLD. Calls that are
not answered will now go to the auto-attendant. Set the number of rings before the calls go the
auto-attendant.
j. Press Flexible Button 21. Display now shows Page “ C ”.
k. Press Flexible Button 8. (Preset FWD Day Timer). Enter how many times the CO lines should
ring before they transfer. (Remember that 4 seconds equals approx. one ring cycle. Standard
could be 16 (four ring cycles) Dial 16 and press HOLD.
NOTE
: Night and Special Modes can also be set to forward after a given set of Rings.
Page B, Flexible Button 16 Preset FWD Night Dest.
Page C, Flexible Button 11 Preset FWD Night Timer
Page B, Flexible Button 17 Preset FWD Special Dest.
Page C, Flexible Button 12 Preset FWD Special Timer
l. If a CO port is available (not used), that port should be placed in CO Line Group 00. (Not Used)
i. Press FLASH and dial 40.
ii. Enter COs that are not being used. (E
xample: Line 4, enter 004004 HOLD)
iii. Press Flexible Button 8 (CO Line Group) by default this is Group 01.
iv. Dial 00 and press HOLD. CO Line Group is now 00.
m. To allow programming from any station:
i. Press FLASH and dial 50. Display will show “Station Programming. Enter station
numbers. Press HOLD for all stations or dial the first and last station to program.
(
example: 100106 for Stations 100 through 106)
ii. Display will show “Page A; Enter Button Number”
iii. Press Flexible Button 18. Display shows ADMIN Access “Disable”.
iv. Dial one (1) and press HOLD. Display changes to enable.
(Programming can now be done from any station.)