Vodavi Starplus STSe, Быстрый старт

Страница: 28 / 72

STSe Quick Start Guide September 2005
- 24 -
VO D AVI
COMMON PROGRAMMING ITEMS (cont’d)
19. Headset Mode
Change Speakerphone from Full Speakerphone to Disable. This does not disable the speakerphone it only
allows it to be disabled when in the headset mode.
a. Speakerphone Mode
* * 3226
FLASH 50
Enter the Station range to be programmed.
Press Flexible Button 20 Display shows Page “B”.
Press Flexible Button 4, “Speakerphone”.
Default is 0 (Full Speakerphone). Change code to "2" (Disable).
b. Headset Mode
(Still on Page “B”)
Press Flexible Button 18, “Headset Mode”, (default is ”0”).
1 = 2.5mm jack located on top left side of phone.
0= Normal handset jack on side of phone.
c. Light Control
The LED light above the display may be programmed for 5 separate functions.
(Still on Page “B”)
Press Flexible Button 15, “Light Control”.
(Default is None. Change as required below and press HOLD.)
0= None
1= Button Incoming Ringing
2= Voicemail
3= Message Wait
4= Headset in use
d. Headset On/Off Button located on the phone
Headset Feature Code is 634. This can be accomplished in Flash 50 Flexible Button Programming or
at each phone press the Speed button twice and then press a Flexible Button to be to be used as the
Headset Button (On/Off Mode) and dial 634).
To place the phone in headset mode press the Headset Button (LED On) and use the phone ON/OFF
Button to answer calls or disconnect from calls. While in the Headset Mode you can still use the
Handset. Only the Speaker has been turned “OFF”.
To remove Headset Mode press the headset button again (LED off).
20. Name in Display
Dial Feature code 690
Enter a name up to seven digits. Letters are two digit input.
(
Example : “A” = Dial 2 and 1; “B” = Dial 2 and 2; “C” = Dial 2 and 3. Space = 11)
21. Off Hook Preference
* * 3226
FLASH 50
Enter stations to be programmed.
Press Flexible Button 20, Page “B”.
Press Button 10.
Dial Button number (
example : the Pool Button, Button 20 by default is a Pool Button).
Press 1 to enable, then press HOLD ( example : 201).