UD101L User Guide Document: UD101L-2
----------------------------------------------------------------------------------------------------------------------------- ---------------
9
2.3.
System connection and Power On
➢
Poor quality HDMI cable and signal source will affect the connection distance and may cause
signal noise or show intermittent image.
➢
To ensure all cables are connected correctly, it is recommended to use locking cables. We can
provide T-Lock cable with certified quality.
➢
Complete system should be connected to one power Distribution Box with proper grounding.
Power on the system after finishing all connections to avoid system damage by floating voltage
among devices.
➢
When power is switched on, the booting time is about 19 seconds and the Input & Output LEDs
on front panel will stay
“Lighted” all the time for the channel with correct input source and output
device connections.
➢
If continuous flashing in power LED, it means the OSD function has been Locked. Please press
[Menu] key for 5 seconds to disable [OSD Locked] function. If system lock is done by remote
controller through [85x] operation, please press [850] to unlock system control.
2.4.
System settings: Box ID, RS232, Ethernet
➢
Box ID, RS232 and Ethernet settings can be executed through OSD menu, WebGui or Gwarp3
PC Tool.
➢
User can control or operate UD101L settings through Ethernet. Default IP address is
192.168.0.100.
➢
When multiple units are used at the same time, user can set different IP address in each
UD101L so that each UD101L can be controlled independently.
2.4.1. Box ID
➢
The range of Box ID is 0 ~ 99 for RS232 command.
➢
If user uses remote controller to execute system operation, the Box ID range is 0 ~ 9.
2.4.2. RS232 settings
➢
RS232 is designed with DB-9 connector. User can select baud rate between 11520 and
9600.
➢
We can provide UART protocol for the control from RS-232 or Ethernet.
T-Lock cable
