Vivitek DU8195Z, Руководство пользователя

Страница: 33 / 69

DU8195Z Series DLP Projector - User Manual
UM81950823EN02
33
Step2: Set the identification number of remote control
The remote control has 2 ways to operate the projector.
• Use 1 remote control to operate 2 projector. Each remote control can record 2 ID control code. Press ID
SET+MENU 5 seconds at the same time. The remote control backlight flashes 1 times then switch to the next ID
control code.
• One remote control corresponds to a single projector. Assuming there are 3 projectors in the room, Then use 3
different remote control to operate each different projector.
Note
• The projector's ID control code is 1, 2, 3, ... 99.
• The ID control code of the infrared remote control is 2 digits, so 01 is equivalent to 1, 02 equivalent to 2 on the
projector.
Example: When the projector's ID control code is 5, press and hold the ID SET on the remote control for about 3 sec-
onds, the POWER LED on the remote control will start to flash. Next press the number 0 on the remote control for one
second, the Power LED will light up to indicate that the setting has been successful, and then press 5 for 1 second.
The Power LED of the remote control lights up again to indicate that the remote control has been successfully set 05
ID control code, at this time you can use the remote control to control the projector with the 5th ID control code.
Press and Hold ID SET for 3 Sec. Power LED is flashing Press two digits for ID number
1
4
7
0
8 9
6
3
5
2
HDMI1 HDMI2 DVI
CLEAR FREEZE ID SET
3G-SDI Displayport HDBaseT
VGA ASPECT COMPONENT
HDMI1 HDMI2 DVI
CLEAR FREEZE ID SET
3G-SDI Displayport HDBaseT
VGA ASPECT COMPONENT
AUTO PC BLANK STATUS
HDMI1 HDMI2 DVI
CLEAR FREEZE ID SET
VGA ASPECT COMPONENT
1
4
7 9
6
3 2
9 7
6 4
3 1 2
3G-SDI Displayport HDBaseT
Erase the identification number of the remote control
You can directly press the ID SET to set a new ID control code. The new ID control code will overwrite the old one.
You can also use the ID SET+CLEAR button on the remote control to clear the ID control code by following steps.
Press ID SET+CLEAR
simultaneously for 5
seconds
1
4
7
0
8 9
6
3
5
2
HDMI1 HDMI2 DVI
CLEAR FREEZE ID SET
3G-SDI Displayport HDBaseT
VGA ASPECT COMPONENT
The backlight of the but -
tons is flashing one time
MENU EXIT
ENTER
1
4
7
0
8 9
6
3
5
2
HDMI1 HDMI2 DVI
CLEAR FREEZE ID SET
3G-SDI Displayport HDBaseT
VGA ASPECT COMPONENT
AUTO PC BLANK STATUS