Specifications
The display range of temperature ... 41˚F to 95˚F (5˚C to 35˚C)
The control range of temperature.... 44˚F to 90˚F (7˚C to 32˚C)
Load Rating............................................... 1 amp per terminal, 1.5 amp
maximum all terminals combined
Swing (cycle rate or differential) ...... Heating is adjustable from 0.2˚ to 2.0˚
Cooling is adjustable from 0.2˚ to 2.0˚
Power source ...........................................18 to 30 VAC, NEC Class II, 50/60 Hz
for hardwire
Battery power from 2 AA Alkaline
batteries
Operating ambient ............................... 32˚F to +105˚F (0˚C to +41˚C)
Operating humidity .............................. 90% non-condensing maximum
Dimensions of thermostat ................. 4.7” W x 4.3” H x 1.1” D
29
30
Specifications
Features
Temporary Hold:
The thermostat will display
HOLD
and
Run
Schedule
on the bottom of the screen when you press the or
key. If you do nothing, the temperature will remain at this setpoint
temporarily for 4 hours. The program setpoint will then replace the
temporary setpoint.
Permanent Hold:
With a temporary hold set, If you press the
Hold
key at the bottom of your screen, you will see
Hold
appear next to
the setpoint temperature in the display. The thermostat will now
permanently stay at this setpoint and can be adjusted using the
or keys.
To Return To Program:
Press the
Run Schedule
key at the bottom of
the screen to exit temporary and permanent holds.
Temporary & Permanent Hold Feature
Filter Change & Other Reminders
If your installing contractor has configured the thermostat to remind
you when the air filter needs changed, you will see a reminder in
the display when your air filter needs changed. the reminder will
be shown in the display after your system has run long enough to
require an air filter change.
Resetting the filter change reminder: When
the reminder is
displayed, you should change your air filter and reset the reminder by
holding down the “
Clean
” key on the left side of the thermostat for 3
seconds. This thermostat also has other maintenance reminders
( Humidity Pad, UV Lamp, and IAQ Cell ), that are reset with the same
procedure.
Remote Sensor Operation
Option #1 - Indoor / Local Temperature Sensor “ON”:
1.
The displayed room temperature will display the average
temperature of the thermostat and all remote sensors.
2.
By pressing the lower left hand corner of the screen, the average
temperature of just the remote sensor(s) will be displayed briefly in
the clock field.
Option #1 - Indoor / Local Temperature Sensor OFF”:
1.
The displayed room temperature will only show the average
temperature of the remote sensor(s).
Option #2 - Outdoor:
1.
The outdoor temperature will alternate briefly with the clock
display.
Option #3 - Floor:
1.
By pressing the lower left hand corner of the screen, the
temperature of the floor sensor will be displayed briefly in the clock
field.
Remote Sensor Operation Options
31
