Vivax Metrotech vLocML2, Руководство пользователя, Страница: 20 / 78

3 vLocPro2 Receiver
Page 14 of 72
3.9 Information Pushbutton (Depth & Current)
Pressing the “i” (information) pushbutton will display the depth to the center of the radiated signal and a
measurement of the current (press the pushbutton briefly – remember if you press and hold – you enter the
setup menu. If you do enter the setup menu – press the “i” pushbutton again to return to the locating screen –
then try again).
The display shown above shows Long/Lat positional informaiton. This is only displayed when the equipment
is paired with a valid GPS system.
IMPORTANT
When locating a cable or pipe (“Line”) – the instrument should be in “Peak”
mode and the depth and current measurements should only be taken with the
bottom of the receiver standing on the ground and directly in line with the
target line.
IMPORTANT
When locating a Sonde – set the mode to Sonde - then the instrument will
automatically be in “Peak” configuration. Depth measurements should only be
taken with the bottom of the receiver standing on the ground and at ninety
degrees to the Sonde.
The accuracy of depth and current readings depends on the quality of the radiated signal being located. If the
signal is symmetrical, the depth reading will be accurate to within 5% of the actual depth. If the signal is
distorted, depth readings will be less accurate. When taking depth measurement, always hold the receiver at
90
0
to the ground.
3.10 Information Pushbutton (Setup Menu)
As described previously, a second function performed by the “i” is to access the SETUP menu. Press and
hold the “i” pushbutton for two seconds to display the SETUP menu. Use the “+”, “-” to navigate through the
various options and use the “M” pushbutton to select. To exit the setup menu, press the “i” pushbutton.
The setup menu allows the user to configure their personal preference, this menu can be accessed and
changed at any time.
Pushbutton
Pushbutton