Vivax Metrotech vLocML2, Руководство пользователя

Страница: 19 / 78

3 vLocPro2 Receiver
Page 13 of 72
3.8 Frequency Selection
The vLocPro2 receiver is capable of locating a large number of frequencies or frequency combinations. A list
of these frequencies can be accessed using the setup menu. Most of these frequencies listed – you will
never use – the setup menu allows you to select the frequencies you wish to use regularly. The frequency
select pushbutton on the main receiver pad is used to toggle through the frequencies defined using the setup
menu. The operating frequency will be shown at the lower right side of the display. You can change this
selection at any time using the setup menu.
The initial frequencies set at the time the unit is supplied are “Power”, “Radio” and the frequencies used by
the transmitter purchased. See the transmitter section for suggestions of which frequency is best suited to
specific applications.
To select the frequencies you wish to use regularly – enter the setup menu
by pressing and holding the “i” pushbutton for 2 seconds. Use the “+” and
“-” to select the word “Frequency” – then press the “M” pushbutton to
display the list of available frequencies.
The “+” and “-” pushbuttons are used to navigate the list of frequencies. To
add a frequency to the “Frequently used list” press the “M” pushbutton and
a dot will appear in the circle alongside the frequency. To deselect a
frequency press the “M” pushbutton and the dot will disappear. Once your selection is completed press “i”
pushbutton once to return to the setup menu, and again to exit the setup menu.
Pushbutton