VITO PRO-POWER VIMLSF12, Инструкция по эксплуатации

Страница: 16 / 24

16
EN
PRACTICAL TIPS
Switch on the equipment.
Work away from the body.
Never move your hands into the
direct vicinity of the work area.
Use only plug-in tools which are in
good working order and undamaged.
PLUG-IN TOOLS
Sawing: Sawing wood and plastic.
Notes on working practice: When
sawing, watch out for foreign bodies
in the material and remove them if
necessary.
Plunge cutting is allowed only in
soft materials such as wood or
plasterboard.
Sanding/grinding: Surface sanding/
grinding at edges, in corners or
hard-to-reach areas. Depending on
choice of sanding/grinding paper for
the sanding/grinding of wood, paint,
lacquer, etc.
Notes on working practice:
This equipment offers particularly
high performance for the sanding/
grinding of hard-to-reach corners
and edges. To sand/grind profiles
and channels you can also work
with just the tip or the edge of the
sanding/grinding disk. Various
sanding/grinding papers are
available, specially designed for the
different types of material you may
be working on and the amount you
wish to remove from the surface.
The amount removed will depend
largely on the choice of sanding/
grinding paper and pressure applied
to the sanding/grinding disk. ´\
SCRAPING
Scraping off old paint or adhesives.
Notes on working practice: Move
the plug-in tool against the area
you want to remove. Begin with
a flat angle of incidence and little
pressure. The surface (e.g. wood,
plaster) may be damaged if too
much pressure is used.
SPEED CONTROL (FIG. 6).
You can select the speed by turning
the speed controller (4).
Plus direction: Higher speed.
Minus direction: Lower speed.
Cleaning, maintenance and ordering
of spare parts.
Always pull out the power plug
before starting any cleaning work.
CLEANING
Keep all safety devices, air vents
and the motor housing free of dirt
and dust as far as possible. Wipe
the equipment with a clean cloth or
blow it down with compressed air at
low pressure. We recommend that
you clean the equipment immediately
after you use it.
Clean the equipment regularly with
a damp cloth and some soft soap.
Do not use cleaning agents or
solvents; these may be aggressive
to the plastic parts in the equipment.
Ensure that no water can get into the
interior of the equipment.
SERVICING
There are no parts inside the
equipment which require additional
maintenance.
Ordering replacement parts.
Please provide the following
information on all orders for spare
parts:
Equipment model/type.
Equipment article number.
Equipment ID number.
Spare part number of the required
spare part.
STORAGE
Store the equipment and accessories
out of children’s reach in a dark
and dry place at above freezing
temperature. The ideal storage
temperature is between 5 and 30
°C. Store the electric tool in its
original packaging.
DISPOSAL AND RECYCLING
The equipment is supplied in
packaging to prevent it from
being damaged in transit. The raw
materials in this packaging can be
reused or recycled. The equipment
and its accessories are made of
various types of material, such
as metal and plastic. Defective
components must be disposed of as
special waste.
Ask your dealer or your local council!
Never place any electric tools in your
household refuse.
To comply with European Directive
2002/96/EC concerning old
electric and electronic equipment
and its implementation in national
laws, old electric tools have to be
separated from other waste and
disposed of in an environment-
friendly fashion, e.g. by taking to a
recycling depot.