Vitek VT-1251 B, Инструкция по эксплуатации

Страница: 5 / 40

5
ENGLISH
BEFORE THE FIRST USE After unit trans-
portation or storage at low temperature, it
is necessary to keep it for at least two hours
at room temperature before switching on.
–
Unpack the iron; remove the protection
from the iron soleplate (13), if any.
–
Check the unit for damages; do not use the
iron in case of damages.
–
Make sure that the voltage of the mains cor-
responds to the operating voltage of the unit.
–
Water tank may contain water residue,
this is normal, as the iron has under-
gone factory quality control
WATER SELECTION
Use tap water to fill the tank. If tap water is
hard, it is recommended to mix it with distilled
water in proportion 1:1, if tap water is too hard,
mix it with distilled water in proportion 1:2 or
use distilled water only.
FILLING THE WATER TANK
Before filling the tank with water, make sure
that the unit is unplugged.
–
Set the temperature control knob (10) to
the “min” position, and set the continuous
steam supply knob (3) to the “
ø
” position.
–
Open the water inlet lid (2).
–
Pour the water into the water tank (9) using
the beaker (14) and then close the water
inlet lid (2).
Note:
• Do not fill the water tank (9) with scent-
ed liquids, vinegar, starch solution,
descaling reagents, chemical agents
etc.
• Do not exceed the “max” mark (12).
• If you need to refill water during ironing,
first switch the iron off and unplug it.
IRONING TEMPERATURE
–
Always check the recommended ironing
temperature indicated on the tag before
ironing.
–
If there is no tag with recommended ironing
temperature, but you know the type of fab-
ric, use the following table to determine the
proper ironing temperature.
Symbol Fabric type (temperature)
•
Synthetics, nylon, acrylic,
polyester (low temperature)
•• Silk/wool (medium temperature)
••• Cotton, linen (high temperature)
max Maximum temperature
–
This table is only valid for smooth materi-
als. Fabrics of other types (crimped, raised
etc.) are best ironed at low temperature.
–
Sort items by ironing temperature first: syn-
thetics to synthetics, wool to wool, cotton
to cotton etc.
–
The iron heats up faster than it cools down.
For this reason it is recommended to begin
ironing at low temperature (for instance,
synthetic fabrics).
–
After that, start ironing at higher tempera-
tures (for instance, silk, wool). Cotton and
linen items should be ironed last.
–
If an item is made of mixed fabrics, the iron
should be set to the lowest ironing tem-
perature (for instance, if an item is made
of acrylic and cotton, it should be ironed at
temperature used for acrylic ironing “•”).
–
If you cannot define the fabric structure,
find a place that is hidden while wearing and
select the ironing temperature experimen-
tally (always start with the lowest tempera-
ture and raise it gradually until you get the
desired result).
–
Corduroy and other fabrics that become
glossy quickly should be ironed strictly in
one direction (in the direction of the pile)
with little pressure.
–
To avoid appearance of glossy spots on
synthetic and silk fabrics, iron them on the
inner side.
SETTING THE IRONING TEMPERATURE
–
Place the iron on its base (8).
–
Insert the power plug into the mains
socket.
VT-1251.indd 5 29.05.2014 12:58:32