Vitals BKZ 5022o, Руководство пользователя

Страница: 14 / 92

Check of oil supply
1. Start engine and for 1 minute hold at a height bar nose 15-20 cm above the
surface of any light, for example, spread out over a paper sheet or on
timber.
2. If the surface there are traces of oil, then the chain lubrication system is
working.
Oil filling
The order of filling oil in the tank:
In operation, the chainsaw, always make sure there is oil in the oil tank, and
the serviceability of its submission.
Before using chainsaws fill the oil tank 260 ml of a special oil for chain
saws.
Chainsaws «Vitals Master» BKZ 5022o, BKZ 5823o and BKZ 5823os
equipped with an adjustable oil pump - while the engine is on the chain and bar
served a necessary portion of the oil. With increasing engine speed increases
oil flow. Before you start a chainsaw necessarily adjust the oil flow (see
"Adjustment of the oil pump).
1. Stop the engine.
2 Thoroughly clean the area around the oil tank and the tank cap of dirt to
prevent the ingress of chips, particles of dust and dirt inside the tank.
3. Remove the fuel cap Oil tank (2) (see Figure 6).
4. Using a funnel to avoid spilling oil on the chain saw body or on the ground,
pour the oil in the oil tank. If oil is spilled on the body or the chainsaw on the
ground, wipe dry.
5 Tighten the fuel cap the oil tank.
.
.
WARNING!
Chainsaw without oil in the oil tank!
Chainsaw operation without the presence of oil in the oil tank,
or if the oil level in the tank is insufficient, is strictly forbidden.
When you operate a chainsaw tire, sprockets and the chain
will not be greased regularly, the effectiveness of the product
will go down, and the life of the tire, chains and sprockets
significantly reduced.
WARNING!
Do not fill the oil tank chainsaw lost their properties of oil and
oil is not designed for the lubrication of the saw chain.
NOTE!
If the chainsaw is not used for a long period of time or to be
transported product, be sure to drain the oil from the oil tank.
figure 7
27 2 6