Vitals BKZ 5022o, Руководство пользователя

Страница: 11 / 92

1. Inspect the product and make sure there is no mechanical damage to the
hull chainsaw bar and chain.
2. Check for loose tires.
3. Check the chain tension.
4. Check the fuel mixture and the fuel oil, where necessary to fill the norm.
5. Check the chain lubrication system.
6. Check that the chain brake.
The greatest influence on the durability and efficiency of the saw sets (tires,
chains, leading and following stars) chainsaws have such factors include
timely and proper chain sharpened teeth, the correct chain tension and
lubrication mechanism serviceable job chain.
If the chain is pulled tight, they are:
creating additional friction, which leads to overheating and irreversible
thermal deformation of the tire;
causes accelerated tire wear, drive and driven sprockets and bearings;
leads to overheating of the motor overload;
increases fuel consumption.
If the chain is stretched slightly, they are:
leads to a devastating shock-dynamic loads during engine start and during
the operation of the product;
significantly increases the risk of kickback and "kickback";
can cause slippage with tire chains and as a consequence, its breakage,
jamming of the drive sprocket and injury to the operator;
causes accelerated tire wear, drive and driven sprockets and bearings.
Checking the chain tension
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
3. Set on the housing front spike bumper 14 (see Figure 1) and secure it with
two screws.
4. Place the chain over the drive sprocket located on the clutch (6). Note the
correct direction of movement of the chain, as shown in Figure 4.
5. Put the tire on the guide pins (1) (a long groove) (see Figure 4).
6. Insert into the groove on the shank chain. This operation start with the
upper branch of the tire.
7. Enter chain in engagement with a driven sprocket disposed on the tire
wear.
8. Shortly move the bus in the direction of arrow (A) (see Figure 4), the chain
is a little stretched.
9. Put the lid mounting tires (3) in such a way that the chain tensioner pin (5) is
exactly the same as the tension hole tire (2) (see Figure 4).
10.Tighten the two nuts (4) without tightening them (see Figure 4).
11. Tension the chain. Stretch chain as long as it does not lie down tightly to the
bottom of the tire.
12.Securely tighten the mounting nuts of the mounting tires.
13.Check the chain tension.
14.Check that the chain brake by locking it by pressing the emergency brake
lever in the direction of tire chains. The chain should not slip on the bus
back or forward.
Control before starting the engine
WARNING!
Edges of the cutting links in the chain is sharp enough. To
avoid injury, the installation is carried out in a chain of dense
protective gloves.
CAUTION!
For safety, always stop the engine before performing any of
the actions in this guide. All actions are performed only when
the engine is cold.
NOTE!
In the operation of chain saws from heating or cooling can be
lengthened or shortened, so you should periodically check
and adjust the chain tension.
21 20